User Manual

6-11
Solar protection, anti-glare protection, utilization of daylight
Anti-glare/solar protection actuators
Siemens Switzerland Ltd
Building Technologies Division
2019www.siemens.com/gamma
6
Stock No. Product No. DT
5WG1501-1AB01 N 501/01 A
N 501/01Combination blind actuator, 4 x AC 230 V, 6 A, 8 x binary inputs
• 8 inputs for DC or AC in the range from 12 to 230 V
• 8 relay contact outputs locked in pairs against each other for controlling 4 × AC 230V sunblind drives
• Contact rated voltage AC 230 V
• Contact rated current 6 A, p.f. = 1
• Electronics powered by a 230 V AC integrated power supply
• Device functional even without bus connection or if the bus communication fails
• Preset on delivery for direct output control for each blind button function via momentary contact
switches connected to the inputs
• Key for switching between bus and direct mode
• Button for each relay contact output, for switching the output in direct mode
• Selectable function for each input when using the ETS:
- Switching status, send binary value
- Switching on leading edge, switching Short/Long
- 1-pushbutton dimming, sunblind control, group control
- 1-bit/8-bit scene control
- 8-bit/16-bit value leading edge, Short/Long
- 16-bit oating point value leading edge, Short/Long
• Or for each pair of inputs:
- Acting directly on the corresponding outputs as blind button
- 2-button dimming with stop telegram or with cyclical sending
- 2-pushbutton sunblind control
• Selectable blocking of each input via a corresponding blocking object
• Sending of input objects after change
• Selectable cyclical input object sending
• Individual or shared conguration of actuator channels
• Communication objects for each blind channel for driving the sun protection into the end positions or
for stopping the procedure and adjusting the blind slats in steps
• Communication objects for setting position of slats and blinds in percentage information
• Automatic opening of the blind slats to a precongured nominal setting after uninterrupted driving
down of the blind from the top to the bottom end position, with integrated 1-bit scene control for
storing and calling up (reproduction) of 2 interim blind and slat settings
• Integrated 1-bit/8-bit scene control, 8 scenes can be integrated per channel
• Optional „Sun“ object for integration in a sunlight tracking control system
• Differentiation between automatic and manual mode and with automatic switchover from automatic
to manual mode for the channel in question by pressing a bus button for manual control of the
corresponding sun protection
• Manual mode taking precedence over automatic position commands
• Optional central command for each device or each channel for switching the relevant channels to
automatic mode and driving the sun protection into the up or down end position
• Alarm: move to safety position, Locking in this position for as long as alarm is active
• Travel lock (e. g. for cleaning the outer shutter/blinds)
• Status objects for each channel for querying or for automatic sending of sun protection and slat
settings as a percentage value
• Optional status objects for reporting that the up or down position has been reached
• Integrated bus coupling unit, Bus connection via bus terminal or contact system to data rail
• Modular installation devices for mounting on TH35 EN 60715 mounting rail
Rated voltage AC 230 V
Rated current 6 A
Number of channels 4
Number of inputs potentialfree 8
Sun position tracking Yes
Wind alarm Yes
Dimension width (1 MW = 18 mm) 8 MW
7-Anti-glare_solar protection actuators.indd 11 26.07.2018 14:23:25