User Manual

6-7
Solar protection, anti-glare protection, utilization of daylight
Anti-glare/solar protection actuators
Siemens Switzerland Ltd
Building Technologies Division
2019www.siemens.com/gamma
6
Stock No. Product No. DT
5WG1522-1AB03 N 522/03 A
N 522/03Venetian blind actuator, 4 x AC 230 V, 8 A, with limit position detection and
sunlight tracking
• For the separate control per actuator channel of a sun protection, damper, door or window drive with
a motor for AC 230 V and electromechanical or electronic limit switches
• Integrated electronics for detection of the actuation of an electromechanical limit switch and with
auto-calibration of the travel time from one limit switch to the other
• Electrically interlocked relays to reverse the direction of rotation
• Relay contacts rated for nominal voltage AC 230 V, 8 A (resistive load)
• Conguration by the user whether all actuator channels are to be identically or individually
parameterized
• Communication objects per actuator channel for moving the sun protection to the limit positions or to
stop travel and for step-by-step adjustment of the blind slats
• Communication objects for moving the sun protection and adjusting the blind slats directly to a new
position (as precisely as drive mechanics permit) by positioning commands as percentage values
• Automatic opening of blind slats up to a set position after the blinds have been lowered without any
stop from the upper to the lower limit position
• Integrated 1-bit scene control for save and recall of 2 favored positions of blind and slats
• Integrated 8-bit scene control and assignment of up to 8 scenes per channel
• Optional object “Sunshine” for activation / deactivation of sunlight tracking of the slats for shading
with greatest possible daylight component
• Differentiation between automatic and manual mode and with automatic switchover from automatic
to manual mode of the respective actuator channel on activation of a bus pushbutton for manual
control of the sun blind
• Priority of manual mode over automatic positioning commands
• Alarm object per device or per channel for moving the sun protection to the congured safety position
in the event of a wind alarm e.g. and with blocking of travel to another position as long as alarm
pending
• Travel blocking object per device or per channel for blocking the sun protection in its current position
(needed during cleaning of an outdoor Venetian blind e.g.)
• Status objects per actuator channel for query or automatic transmission of sun blind and slat position
as percentage value
• Electronics powered via an integrated power supply unit for AC 230 V
• Green LED for displaying the 230 V operating voltage
• Pushbutton for switchover between bus mode and direct mode
• Yellow LED for display of activated direct mode
• Two pushbuttons each per actuator channel for drive control in direct mode
• Integrated in the actuator housing and operational if the actuator is supplied with AC 230 V (even if
bus voltage missing or communication not operational)
• Integrated bus coupling unit with only half a standard bus load
• Bus connection via bus terminal or contact system to data rail
• Modular installation devices for mounting on TH35 EN 60715 mounting rail
Rated voltage AC 230 V
Rated current 8
Number of channels 4
Sun position tracking Yes
Automatic detection of end positions Yes
Wind alarm Yes
Dimension width (1 MW = 18 mm) 6 MW
7-Anti-glare_solar protection actuators.indd 7 26.07.2018 14:23:23