User Manual

2-25
Output devices
Binary output devices
Switching actuators / Modular installation system
Siemens Switzerland Ltd
Building Technologies Division
2019www.siemens.com/gamma
2
Stock No. Product No. DT
5WG1512-4AB23 RL 512/23 A
RL 512/23Switching Actuator, 1 x AC 230 V, 16 AX, C load
• One relay contact as switching element
• Bus-powered electronics
• Integrated bus coupling unit, Bus connection via bus terminal block
• Type of protection: IP 20
• Rated contact voltage 230 V AC
• Rated contact frequency: 50/60 Hz
• Rated contact current 16 AX / 20 A
• Screw-less terminals for connection and through-wiring of untreated single-core, stranded or multi-
core conductors, 0.5...2.5 mm
2
• For mounting in AP 118 automation module box or AP 641 room control box
• Selectable operating mode (normal mode, time switch mode)
• Selectable relay mode (NO contact / NC contact)
• Status object as an optional addition
• Variable On and Off delay times
• Selectable logic operation (AND/OR) of two communication objects
• Selectable switching state at bus voltage failure and recovery
• Optional addition of a night mode object for time-limited switching On of the output (and hence the
illumination) at night
• Variable On period at night or time switch mode
• Selectable post-triggering of the On period (On period extension) in time switch mode
• Selectable warning signal prior to imminent switching-off by means of three-times short off and on
switching (ashing) at night or in time switch mode
• Selectable function:
- Including additional communication object for manual override of an output
- Selectable forced control, including additional communication object for switching an output on or off
in forced mode
- Selectable counting of operating hours with threshold monitoring of the operating hours
- Selectable counting of load cycles with threshold monitoring of the load cycles
• Integrated 8-bit scene control and linking of each output into up to 8 scenes
The AP 641 room control box and AP 118 automation module box must be ordered separately.
See chapter Modular Installation System - Room control box - Module boxes.
Base function Only Switching
Rated voltage AC 230 V
Rated current 16 A
Number of channels 1
Switch-off warning Yes
Dimensions (W x H x D) 86,5 x 47,8 x 36,2 mm
13-Switching actuators _ DIN rail mounted devices.indd 25 23.07.2018 14:09:03