User Manual

GAMMA instabus

Release: 12/2015

Application Program Bus Interface Modules M130, M131, M132 and M135

Runtime Environment for KNX-Processors 184/11 and 184/21

Technical Manual pages 17 Siemens AG

Building Technologies

Control Products and Systems

Subject to change without further notice. D-93009 Regensburg

Last click on button "OK" to store the download file and the settings in the PG-FP5 flash

programmer. Use command "ep" (erase and program) to download the S19 (or S37) file to

the device. After successful programming download via bus the S19 file that was created by

the modifier with the config_pgfp4.xml file. Because this file contains only load controls the

download will be finished very quickly. For the download a tool is necessary that is able to

interpret the load controls (for example the "KNX Device Editor").