User Manual

Control
Basic Operator Panel 2 (BOP-2)
Operating Instructions, 02/2016, A5E37143404B AA
25
Editing single digits
It is possible to edit the individual digits of the setpoint screen. To enter the single digit
editing mode, press
until the "SP DIGIT" screen is displayed.
The process of editing the individual digits is shown in the following figure:
Image 7-2 Editing individual digits
Jog
The Jog function, when selected, will allow the motor to be manually rotated by a pre-
determined value with each press of
. If is pressed continuously, the motor will rotate
continuously until
is released.
To enable or disable the Jog function, the actions shown in the following figure should be
performed:
Image 7-3 Jog function