User Manual

Basic Operator Panel 2 (BOP-2)
Operating Instructions, 02/2016, A5E37143404B AA
23
Control
7
Introduction
The control menu allows the user to access the following functions of the Inverter:
● Setpoint
● Jog
● Reverse
The menu is selected by using the
and keys to move
the menu bar to the required menu.
Pressing
will confirm the selection and display the top
level menu.
The Inverter must be in HAND mode before any functions
can be a
ccessed. If HAND mode is not selected a notice
screen is
displayed stating that the Inverter is not in HAND
mode.
The HAND mode is selected by pressing the
key.
Note
Hand/Auto mode
If the
key is pressed when the Inverter is in AUTO mode, the user is taken directly to the
Setpoint screen.
The individual functions are described below.