Operating Instructions

List of Parameters

Parameters

1-377

SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 06/2011

Description: Diagnostics parameter to display additional information for internal software errors.

Note: Only for internal Siemens troubleshooting.

Description: Sets the signal source to switch in/switch out the free technology controller 0.

1 signal: The technology controller is switched in.

0 signal: The technology controller is switched out.

r9999[0...99] Software error internal supplementary diagnostics / SW_err int diag

Access level: 4 Calculated: - Data type: Unsigned32

Can be changed: - Scaling: - Data set: -

Units group: - Unit selection: -

Min Max Factory setting

- - -

p11000 BI: Free tec_ctrl 0 enable / Ftec0 enab

Access level: 2 Calculated: - Data type: U32 / Binary

Can be changed: U, T Scaling: - Data set: -

Units group: - Unit selection: -

Min Max Factory setting

- - 0