Operating Instructions

Parameters
Overview of parameters
1-18
© Siemens AG 2008 - 2013 All Rights Reserved
SINAMICS G120 CU230P-2 Control Units List Manual (LH9), 01/2013
Bit array
For parameters with bit arrays, the following information is provided about each
bit:
• Bit number and signal name
• Meaning for signal states 1 and 0
• Function diagram (FP) (optional).
The signal is shown on this function diagram.
Dependency
Conditions that must be fulfilled in conjunction with this parameter. Also includes
special effects that can occur between this parameter and others.
Where necessary, "See also:" indicates the following information:
• List of other relevant parameters to be considered.
• List of faults and alarms to be considered.
Safety notices
Important information that must be observed to avoid the risk of physical injury or
material damage.
Information that must be observed to avoid any problems.
Information that the user may find useful.
Danger
The description of this safety notice can be found at the
beginning of this manual (see Safety notices).
Warning
The description of this safety notice can be found at the
beginning of this manual (see Safety notices).
Caution
The description of this safety notice can be found at the
beginning of this manual (see Safety notices).
Caution The description of this safety notice can be found at the
beginning of this manual (see Safety notices).
Notice The description of this safety notice can be found at the
beginning of this manual (see Safety notices).
Note Information that the user may find useful.