Operating Instructions

Parameters
List of Parameters
1-458
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 06/2011
Description: Sets the signal source for the input pulse I of instance PDE 3 of the closing delay device.
Description: Setting parameter for pulse delay time T in milliseconds of instance PDE 3 of the closing delay device.
Description: Display parameter for output pulse Q of instance PDE 3 of the closing delay device.
Description: Setting parameter for the run-time group in which instance PDE 3 of the closing delay device is to be called.
Value: 5: Run-time group 5
6: Run-time group 6
9999: Do not calculate
Description: Setting parameter for the run sequence of instance PDE 3 within the run-time group set in p20342.
Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run
sequence value.
p20339 BI: PDE 3 input pulse I / PDE 3 inp_pulse I
Access level: 3 Calculated: - Data type: U32 / Binary
Can be changed: T Scaling: - Data set: -
Units group: - Unit selection: -
Min Max Factory setting
- - 0
p20340 PDE 3 pulse delay time in ms / PDE 3 t_del ms
Access level: 3 Calculated: - Data type: FloatingPoint32
Can be changed: T Scaling: - Data set: -
Units group: - Unit selection: -
Min Max Factory setting
0.00 60000.00 0.00
r20341 BO: PDE 3 output Q / PDE 3 output Q
Access level: 3 Calculated: - Data type: Unsigned32
Can be changed: - Scaling: - Data set: -
Units group: - Unit selection: -
Min Max Factory setting
- - -
p20342 PDE 3 run-time group / PDE 3 RTG
Access level: 3 Calculated: - Data type: Integer16
Can be changed: T Scaling: - Data set: -
Units group: - Unit selection: -
Min Max Factory setting
5 9999 9999
p20343 PDE 3 run sequence / PDE 3 RunSeq
Access level: 3 Calculated: - Data type: Unsigned16
Can be changed: T Scaling: - Data set: -
Units group: - Unit selection: -
Min Max Factory setting
0 32000 900