Installation Instructions
Table Of Contents
- Power Module PM230, IP20 / Push-through technology (PT)
- Legal information - Warning notice system
- Table of contents
- 1 Changes in this manual
- 2 Fundamental safety instructions
- 3 Introduction
- 4 Installing/mounting
- 5 Connecting
- 6 Service and maintenance
- 7 Technical specifications
- 7.1 Overload capability of the inverter
- 7.2 Cable cross-sections and tightening torques
- 7.3 Electromagnetic compatibility - overview
- 7.4 Ambient conditions
- 7.5 General technical data
- 7.6 Detailed technical data
- 7.7 Restrictions for special ambient conditions
- 7.8 Electromagnetic compatibility of variable-speed drives
- 8 Spare parts and accessories
- A Appendix
- Index
7.8.3 EMC limit values in South Korea
넩 韥韥鱉 꽺ꓩ끞(A 鞾) 놹녅볁놶뼞韥韥ꈑ 볅ꎙ녅 鿅鱉 ꩡ끞녅鱉 넩 뇅냹 늱넍뼍겑韥 ꗉꄱꐥ,
閵뇊뀭넍 덵꾢꾅 ꩡ끞뼍鱉 阸냹 ꑞ놶냱ꈑ 뼞鱽鲙.
)RUVHOOHUVRUXVHUVSOHDVHNHHSLQPLQGWKDWWKLVGHYLFHLVDQ$JUDGHHOHFWURPDJQHWLFZDYHGHYLFH
7KLVGHYLFHLVLQWHQGHGWREHXVHGLQDUHDVRWKHUWKDQKRPH
The EMC limit values to be observed for Korea correspond to the limit values of the EMC
product standard for variable-speed electric drives EN 61800-3 of category C2 or the limit value
class A, Group 1 to KN11.
By implementing appropriate additional measures, the limit values according to category C2
or limit value class A, Group 1, are observed.
Additional measures, such as the use of an additional RFI suppression filter (EMC filter), may
be necessary.
In addition, measures for EMC-compliant configuration of the plant or system are described
in detail in this manual and in the Configuration manualEMC installation guideline (http://
support.automation.siemens.com/WW/view/en/60612658).
The final statement on compliance with the applicable standard is given by the respective label
attached to the individual device.
Technical specifications
7.8 Electromagnetic compatibility of variable-speed drives
Power Module PM230, IP20 / Push-through technology (PT)
76 Hardware Installation Manual, 08/2016, A5E34331322B AB