Manualshelf

Operating Instructions

ManualsBrandsSiemens ManualsVariable Speed DriveEU-Declaration of Conformity, SINAMICS G120
41424344454647484950
Installing
Installing the operator panel
5
47 |
118
Siemens
A5E36496664A_f
Smart Infrastructure 2021-10-11
7. Route the signal cables in such a way that you can completely close the front
doors after wiring the terminal strip.
8. If you use shielded cables, then you must connect the shield to the mounting
plate of the control cabinet or to the shield support of the variable speed drive
through a good electrical connection and a large surface area. See also: EMC
design guidelines (SIOS Entry-ID: 60612658).
9. Use strain relief.
5.5 Installing the operator panel
To connect up the operator panel to the Control Unit, proceed as follows:
Figure 20: Operator panel
1. Fit the operator panel on the Control Unit as illustrated in the diagram.
2. Press the operator panel against the Control Unit until it audibly engages.