Operating Instructions

Parameters

List of Parameters

1-340

SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 06/2011

Description: Sets whether the real-time clock outputs an alarm if the time is not synchronized (e.g. if the power supply was

switched off for an extended period).

Value: 0: Alarm A01098 de-activated

1: Alarm A01098 activated

Dependency: Refer to: A01098

Note: RTC: Real-time clock

Description: Sets the activation/de-activation of the parameters for timers DTC1, DTC2, DTC3.

For p8409 = 0, the following applies:

DTC1 parameters p8410, p8411, p8412 are inactive and can be set. Binector output r8413.0 = 0.

DTC2 parameters p8420, p8421, p8422 are inactive and can be set. Binector output r8423.0 = 0.

DTC3 parameters p8430, p8431, p8432 are inactive and can be set. Binector output r8433.0 = 0.

For p8409 = 1, the following applies:

DTC1 parameters p8410, p8411, p8412 are active and cannot be set. Binector outputs r8413 are active.

DTC2 parameters p8420, p8421, p8422 are active and cannot be set. Binector outputs r8423 are active.

DTC3 parameters p8430, p8431, p8432 are active and cannot be set. Binector outputs r8433 are active.

Value: 0: DTC inactive and can be set

1: DTC active and cannot be set

Dependency: Refer to: p8410, p8411, p8412, r8413, p8420, p8421, p8422, r8423, p8430, p8431, p8432, r8433

Note: DTC: Digital Time Clock (timer)

RTC: Real-time clock

p8405 Activate/de-activate RTC alarm A01098 / RTC A01098 act

Access level: 3 Calculated: - Data type: Integer16

Can be changed: T Scaling: - Data set: -

Units group: - Unit selection: -

Min Max Factory setting

0000 bin 0001 bin 0001 bin

p8409 RTC DTC activation / RTC DTC act

Access level: 3 Calculated: - Data type: Integer16

Can be changed: U, T Scaling: - Data set: -

Units group: - Unit selection: -

Min Max Factory setting

0000 bin 0001 bin 0001 bin