Operating Instructions

SINAMICS G120 CU230P-2 Control Units
List Manual, 04/2018, A5E33838102
375
2 Parameters
2.2 List of parameters
Description: Displays the status of the digital inputs of the PM330 power unit.
Dependency: Refer to: r4023
Note: DI: Digital Input
Description: Displays the inverted status of the digital inputs of Power Module 330 (PM330).
Dependency: Refer to: r4022
Note: DI: Digital Input
Description: Displays the status of the digital outputs of Power Module 330 (PM330).
Note: DO: Digital Output
r4022.0...3 CO/BO: PM330 digital inputs status / PM330 DI status
PM330 Access level: 3 Calculated: - Data type: Unsigned32
Can be changed: - Scaling: - Dyn. index: -
Unit group: - Unit selection: - Func. diagram: -
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 DI 0 (X9.3, external alarm) High Low -
01 DI 1 (X9.4, external fault) High Low -
02 DI 2 (X9.5, Emergency Off category 0) High Low -
03 DI 3 (X9.6, Emergency Off category 1) High Low -
r4023.0...3 CO/BO: PM330 digital inputs status inverted / PM330 DI stat inv
PM330 Access level: 3 Calculated: - Data type: Unsigned32
Can be changed: - Scaling: - Dyn. index: -
Unit group: - Unit selection: - Func. diagram: -
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 DI 0 (X9.3, external alarm) High Low -
01 DI 1 (X9.4, external fault) High Low -
02 DI 2 (X9.5, Emergency Off category 0) High Low -
03 DI 3 (X9.6, Emergency Off category 1) High Low -
r4047 PM330 digital outputs status / PM330 DO status
PM330 Access level: 3 Calculated: - Data type: Unsigned32
Can be changed: - Scaling: - Dyn. index: -
Unit group: - Unit selection: - Func. diagram: -
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 DO 0 (X9.8: enable signal UDC link
charged)
High Low -
01 DO 1 (X9.11/X9.12: main contactor control) High Low -