Operating Instructions

ManualsBrandsSiemens ManualsVariable Speed DriveEU-Declaration of Conformity, SINAMICS G120

341

342

343

344

345

346

347

348

349

350

2 Parameters

2.2 List of parameters

SINAMICS G120 CU230P-2 Control Units

350 List Manual, 04/2018, A5E33838102

For index 4, 5, 6:

Displays the relative error of the current inversion (id(psid, iq) - id) / p2950:

- r2969[4]: error with respect to direct axis current for iq = 0

- r2969[5]: error with respect to direct axis current for iq = 0.5 * p2950

- r2969[6]: error with respect to direct axis current for iq = p2950

Index: [0] = d-current

[1] = d-flux iq0

[2] = d-flux iq1

[3] = d-flux iq2

[4] = d-current error iq0

[5] = d-current error iq1

[6] = d-current error iq2

Note: RESM: reluctance synchronous motor (synchronous reluctance motor)

Description: Sets the delay time for external fault 3.

Dependency: Refer to: p2108, p3111, p3112

Refer to: F07862

Description: Sets the signal source for the enable signal of external fault 3.

External fault 3 is initiated by the following AND logic operation:

- BI: p2108 negated

- BI: p3111

- BI: p3112 negated

Dependency: Refer to: p2108, p3110, p3112

Refer to: F07862

Description: Sets the signal source for the negated enable signal of external fault 3.

External fault 3 is initiated by the following AND logic operation:

- BI: p2108 negated

- BI: p3111

- BI: p3112 negated

Dependency: Refer to: p2108, p3110, p3111

Refer to: F07862

p3110 External fault 3 switch-on delay / Ext fault 3 t_on

Access level: 3 Calculated: - Data type: Unsigned16

Can be changed: U, T Scaling: - Dyn. index: -

Unit group: - Unit selection: - Func. diagram: 2546

Min Max Factory setting

0 [ms] 1000 [ms] 0 [ms]

p3111[0...n] BI: External fault 3 enable / Ext fault 3 enab

Access level: 3 Calculated: - Data type: U32 / Binary

Can be changed: U, T Scaling: - Dyn. index: CDS, p0170

Unit group: - Unit selection: - Func. diagram: -

Min Max Factory setting

- - 1

p3112[0...n] BI: External fault 3 enable negated / Ext flt 3 enab neg

Access level: 3 Calculated: - Data type: U32 / Binary

Can be changed: U, T Scaling: - Dyn. index: CDS, p0170

Unit group: - Unit selection: - Func. diagram: -

Min Max Factory setting

- - 0