Operating Instructions

ManualsBrandsSiemens ManualsVariable Speed DriveEU-Declaration of Conformity, SINAMICS G120

321

322

323

324

325

326

327

328

329

330

List of Parameters

Parameters

1-323

SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 06/2011

Description: Displays the status of NAMUR signal bit bar.

The faults or alarms are assigned to the appropriate signaling/message classes and influence a specific message

bit.

Description: Displays the fault value of the oldest active fault.

Dependency: Refer to: r2131, r3132

Description: Displays the component number of the oldest fault that is still active.

Dependency: Refer to: r2131, r3131

Description: Sets the signal source for the speed actual value of the load monitoring.

Dependency: Refer to: r2169, p2181, p2192, p2193, p3231

Refer to: A07920, A07921, A07922, F07923, F07924, F07925

Note: The parameter is only effective for p2193 = 2.

r3113.0...15 CO/BO: NAMUR message bit bar / NAMUR bit bar

Access level: 3 Calculated: - Data type: Unsigned16

Can be changed: - Scaling: - Data set: -

Units group: - Unit selection: -

Min Max Factory setting

- - -

Bit field: Bit Signal name 1 signal 0 signal FP

00 Fault drive converter data electronics / soft-

ware error

Yes No -

01 Line supply fault Yes No -

02 DC link overvoltage Yes No -

03 Fault drive converter power electronics Yes No -

04 Drive converter overtemperature Yes No -

05 Ground fault Yes No -

06 Motor overload Yes No -

07 Bus error Yes No -

08 External safety-relevant shutdown Yes No -

10 Error communication internal Yes No -

11 Fault infeed Yes No -

15 Other faults Yes No -

r3131 CO: Current flt value / Current flt value

Access level: 3 Calculated: - Data type: Integer32

Can be changed: - Scaling: - Data set: -

Units group: - Unit selection: -

Min Max Factory setting

- - -

r3132 CO: Actual component number / Act comp_no.

Access level: 3 Calculated: - Data type: Integer32

Can be changed: - Scaling: - Data set: -

Units group: - Unit selection: -

Min Max Factory setting

- - -

p3230[0...n] CI: Load monitoring, speed actual value / Load monit n_act

Access level: 3 Calculated: - Data type: U32 / FloatingPoint32

Can be changed: T Scaling: p2000 Data set: CDS, p0170

Units group: - Unit selection: -

Min Max Factory setting

- - 0