Operating Instructions

Product information
Components
4
27 |
118
Siemens
A5E36496664A_f
Smart Infrastructure 2021-10-11
Function Status Symbol Comments
Command
source
Auto Auto - the converter receives the command signals
from the network controller
JOG Is displayed if the JOG function is activated
Manual Hand - the converter is under control of the IOP-2-BT
Variable speed
drive
state
Ready
In operation Symbol rotates when the motor is running.
Fault
display
Fault
Alarm display Alarm
Save in the RAM Active Indicates that all recent changes to parameters have
been saved in RAM only. In the event of a power
failure, then all recent changes saved to RAM will be
lost. To prevent loss of parameter data a RAM-to-
ROM save must be performed.
PID autotuning Active
Hibernation Active
Write protection Active Parameters cannot be changed.
Know-how
protection
Active Parameters cannot be viewed or modified
ESM Active Essential services mode (fire control)
Battery condition Active The battery status is only shown when the IOP-2-BT
Hand-held kit is used.
Table 4: IOP-2-BT screen symbols
IOP-2-BT - screen
symbols