Operating Instructions

ManualsBrandsSiemens ManualsVariable Speed DriveEU-Declaration of Conformity, SINAMICS G120

List of parameters

Parameters

1-35

SINAMICS G120 CU230P-2 Control Units List Manual (LH9), 01/2013

Caution: p2080 is used to define the signal sources of the PROFIdrive status word interconnection.

Note: Re bit 03:

This signal is inverted if it is interconnected to a digital output.

Re r0052:

The status bits have the following sources:

Bit 00: r0899 Bit 0

Bit 01: r0899 Bit 1

Bit 02: r0899 Bit 2

Bit 03: r2139 Bit 3 (or r1214.10 for p1210 > 0)

Bit 04: r0899 Bit 4

Bit 05: r0899 Bit 5

Bit 06: r0899 Bit 6

Bit 07: r2139 Bit 7

Bit 08: r2197 Bit 7

Bit 09: r0899 Bit 7

Bit 10: r2197 Bit 6

Bit 11: r0056 Bit 13 (negated)

Bit 13: r2135 Bit 14 (negated)

Bit 14: r2197 Bit 3

Bit 15: r2135 Bit 15 (negated)

Description: Display and BICO output for status word 2.

Caution: p2081 is used to define the signal sources of the PROFIdrive status word interconnection.

02 Operation enabled Yes No -

03 Fault present Yes No -

04 Coast down active (OFF2) No Yes -

05 Quick Stop active (OFF3) No Yes -

06 Switching on inhibited active Yes No -

07 Alarm present Yes No -

08 Deviation setpoint/actual speed No Yes -

09 Control request Yes No -

10 Maximum speed reached Yes No -

11 I, M, P limit reached No Yes -

13 Alarm motor overtemperature No Yes -

14 Motor rotates forwards Yes No -

15 Alarm drive converter overload No Yes -

r0053.0...11 CO/BO: Status word 2 / ZSW 2

Access level: 2 Calculated: - Data type: Unsigned16

Can be changed: - Scaling: - Dyn. index: -

Units group: - Unit selection: - Func. diagram: -

Min Max Factory setting

- - -

Bit field: Bit Signal name 1 signal 0 signal FP

00 DC braking active Yes No -

01 |n_act| > p1226 (n_standstill) Yes No -

02 |n_act| > p1080 (n_min) Yes No -

03 I_act >= p2170 Yes No -

04 |n_act| > p2155 Yes No -

05 |n_act| <= p2155 Yes No -

06 |n_act| >= r1119 (n_set) Yes No -

07 Vdc <= p2172 Yes No -

08 Vdc > p2172 Yes No -

09 Ramp-up/ramp-down completed Yes No -

10 Technology controller output at the lower

limit

Yes No -

11 Technology controller output at the upper

limit

Yes No -