Operating Instructions

Parameters

Overview of parameters

1-14

SINAMICS G120 CU230P-2 Control Units List Manual (LH9), 01/2013

Scaling

Specification of the reference variable with which a signal value is automatically

converted for a BICO interconnection.

The following reference variables are available:

• p2000 ... p2006: Reference speed, reference voltage, etc.

• PERCENT: 1.0 = 100 %

• 4000H: 4000 hex = 100 %

Dyn. index (dynamic index)

For parameters with a dynamic index [0...n], the following information is specified

here:

• Data set (if available).

• Parameter for the number of indices (n = number - 1).

The following information can be contained in this field:

• "CDS, p0170" (Command Data Set, CDS count)

Example:

p1070[0]  main setpoint [command data set 0]

p1070[1]  main setpoint [command data set 1], etc.

• "DDS, p0180" (Drive Data Set, DDS count)

• "MDS, p0130" (Motor Data Set, MDS count)

• "PDS, p0120" (Power unit Data Set, PDS count)

Data sets can only be created and deleted when p0010 = 15.

• U Operation U: Run

Pulses are enabled.

• T Ready T: Ready to run

The pulses are not enabled and the status "C(x)" is not active.

Note:

Information on the data sets can be taken from the following references:

Operating Instructions SINAMICS G120 Frequency Converter with

CU230P-2 HVAC, CU230P-2 DP, CU230P-2 CAN Control Units.