Operating Instructions

Parameters

List of Parameters

1-388

SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 06/2011

Description: Sets the time constant for the differentiation (D component) of the free technology controller 1.

Note: Value = 0: Differentiation is de-activated.

Description: Sets the proportional gain (P component) of the free technology controller 1.

Note: Value = 0: The proportional gain is de-activated.

Description: Sets the integral time (I component, integrating time constant) of the free technology controller 1.

Note: Value = 0: The integral time is disabled.

If the parameter is set to zero during operation, the I component retains its most recent value.

Description: Sets the maximum limit of the free technology controller 1.

Dependency: Refer to: p11192

Note: The maximum limit must always be greater than the minimum limit (p11191 > p11192).

Description: Sets the minimum limit of the free technology controller 1.

Dependency: Refer to: p11191

Note: The maximum limit must always be greater than the minimum limit (p11191 > p11192).

p11174 Free tec_ctrl 1 differentiation time constant / Ftec1 D comp T

Access level: 2 Calculated: - Data type: FloatingPoint32

Can be changed: U, T Scaling: - Data set: -