Operating Instructions
3. Remove the gland plate from the bottom of the inverter.
%ROWLQJSODWH
1P
&DEOHJODQGV
1P
5XEEHUVOHHYHV
Diameter of the holes in the gland plate:
20.5 mm Control cables
40.5 mm Mains and motor cables, FSD
50.5 mm Mains and motor cables, FSE
63.5 mm Mains and motor cables, FSF
4. Assemble the cable glands with the prepared cables and EMC cable glands for the control
cables.
5. Seal any unused bushings with a rubber sleeve.
6. Secure the gland plate to the inverter enclosure. Tightening torque 2 Nm.
Make sure that the seal of the gland plate is not damaged.
7. Connect the mains supply and the motor.
0DLQVVXSSO\ 0RWRU
8/
9/
:/
3(
8
9
:
8. Close the door of the Power Module.
Make sure that the door seal of the Power Module is not damaged.
Line supply and motor are connected to the FSD … FSF Power Modules.
❒
Installing
4.4 Connecting the line supply and motor
Converter with the CU230P-2 Control Units
Operating Instructions, 04/2018, FW V4.7 SP10, A5E34257946B AF 97