Operating Instructions

ManualsBrandsSiemens ManualsVariable Speed DriveEU-Declaration of Conformity, SINAMICS G120

111

112

113

114

115

116

117

118

119

120

List of parameters

Parameters

1-115

SINAMICS G120 CU230P-2 Control Units List Manual (LH9), 01/2013

Note: OC: Operating condition

Re bit 10:

If p0700 = 2 is set, bit 10 always shows "1".

Description: Displays the status word of the sequence control.

Note: Re bits 00, 01, 02, 04, 05, 06, 09:

For PROFIdrive, these signals are used for status word 1.

Description: Displays or sets the PROFIBUS address for PROFIBUS interface on the Control Unit.

The address can be set as follows:

1) Using the DIP switch on the Control Unit.

--> p0918 can then only be read and displays the selected address.

--> A change only becomes effective after a POWER ON.

2) Using p0918

--> Only if all of the DIP switches are set to ON or OFF.

--> The address is saved in a non-volatile fashion using the function "copy from RAM to ROM".

--> A change only becomes effective after a POWER ON.

Notice: For p0014 = 1, the following applies:

After the value has been modified, no further parameter modifications can be made and the status is shown in

r3996. Modifications can be made again when r3996 = 0.

For p0014 = 0, the following applies:

Before a changed setting becomes permanently effective, a non-volatile RAM to ROM data save is required. To do

this, set p0971 = 1 or p0014 = 1.

03 Operation enable Yes No -

04 Ramp-function generator enable Yes No -

05 Continue ramp-function generator Yes No -

06 Speed setpoint enable Yes No -

08 Jog 1 Yes No -

09 Jog 2 Yes No -

10 Master ctrl by PLC Yes No -

r0899.0...11 CO/BO: Status word sequence control / ZSW seq_ctrl

Access level: 2 Calculated: - Data type: Unsigned16

Can be changed: - Scaling: - Dyn. index: -

Units group: - Unit selection: - Func. diagram: 1530, 2503

Min Max Factory setting

- - -

Bit field: Bit Signal name 1 signal 0 signal FP

00 Rdy for switch on Yes No -

01 Ready Yes No -

02 Operation enabled Yes No -

03 Jog active Yes No -

04 No coasting active OFF2 inactive OFF2 active -

05 No Quick Stop active OFF3 inactive OFF3 active -

06 Switching on inhibited active Yes No -

07 Drive ready Yes No -

08 Controller enable Yes No -

09 Control request Yes No -

11 Pulses enabled Yes No -

p0918 PROFIBUS address / PB address

CU230P-2_DP Access level: 2 Calculated: - Data type: Unsigned16

Can be changed: T Scaling: - Dyn. index: -

Units group: - Unit selection: - Func. diagram: 1520, 2410

Min Max Factory setting

1 126 126