Operating Instructions

ManualsBrandsSiemens ManualsVariable Speed DriveEU-Declaration of Conformity, SINAMICS G120

351

352

353

354

355

356

357

358

359

360

Parameters

List of Parameters

1-352

SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 06/2011

Description: Sets the bit timing for the C_CAN controller to the associated and selected bit rate (p8622).

Bits are distributed to the following parameters of the C_CAN controller in p8623[0...7]:

Bit 0 ... 5: BRP (Baud Rate Prescaler)

Bit 6 ... 7: SJW (Synchronization Jump Width)

Bit 8 ... 11: TSEG1 (Time Segment 1, before the sampling point)

Bit 12 ... 14: TSEG2 (Time Segment 2, after the sampling point)

Bit 15: Reserved

Bit 16 ... 19: BRPE (Baud Rate Prescaler Extension)

Bit 20 ... 31: Reserved

Example:

Bit rate = 20 kbit/s --> p8622 = 6 --> associated bit timing is in p8623[6] --> 0001 2FB6

Index: [0] = 1 Mbit/s

[1] = 800 kbit/s

[2] = 500 kbit/s

[3] = 250 kbit/s

[4] = 125 kbit/s

[5] = 50 kbit/s

[6] = 20 kbit/s

[7] = 10 kbit/s

Dependency: Refer to: p8622

Note: The parameter is not influenced by setting the factory setting.

p8623[0...7] CAN Bit Timing selection / Bit timing select

CU230P-2 CAN Access level: 3 Calculated: - Data type: Unsigned32

Can be changed: T Scaling: - Data set: -

Units group: - Unit selection: -

Min Max Factory setting

0000 hex 000F 7FFF hex [0] 1405 hex

[1] 1605 hex

[2] 1C05 hex

[3] 1C0B hex

[4] 1C17 hex

[5] 1C3B hex

[6] 0002 1C15 hex

[7] 0004 1C2B hex