Operating Instructions

SINAMICS G120 CU230P-2 Control Units
List Manual, 04/2018, A5E33838102
387
2 Parameters
2.2 List of parameters
Description: Sets and displays the date on the real-time clock in year, month, and day.
The date is stored in the internal clock block in the drive and continues to run even if the supply voltage for the
Control Unit is interrupted (for approx. 5 days).
Recommendation: When the date is set as an index, the day should always be written last because, if a date is invalid, the day is always
corrected to the last valid day in that particular month of the year.
Index: [0] = Day (1 ... 31)
[1] = Month (1 ... 12)
[2] = Year (YYYY)
Note: The time from p8400 and p8401 is used to display the fault and alarm times.
When displaying the fault time and alarm time, the switchover to daylight saving time is not taken into account.
The parameter is not reset when the factory setting is restored (p0010 = 30, p0970).
RTC: Real-time clock
Description: Setting the daylight saving time.
The factory setting corresponds to the time change for central european summer time (CEST). You only have to set
p8402[0] = 1 to activate CEST.
Index: [0] = Difference (0 ... 3 hours)
[1] = Start of month (1 ... 12)
[2] = Start of the week of the month (1 ... 4, 6)
[3] = Start of weekday (1 ... 7)
[4] = Start of hour (0 ... 23)
[5] = End of month (1 ... 12)
[6] = End of the week of the month (1 ... 4, 6)
[7] = End of weekday (1 ... 7)
[8] = End of hour (0 ... 23)
Note: The switchover to daylight saving time only effects the RTC and DTC parameters (p8400 ... p8433).
When displaying the fault time and alarm time, the switchover to daylight saving time is not taken into account.
There must be at least two months between the start and end of daylight saving time.
For index 0:
0: daylight saving time switchover deactivated
1 ... 3: time difference
p8401[0...2] RTC date / RTC date
Access level: 3 Calculated: - Data type: Unsigned16
Can be changed: U, T Scaling: - Dyn. index: -
Unit group: - Unit selection: - Func. diagram: -
Min Max Factory setting
0 9999 [0] 1
[1] 1
[2] 1970
p8402[0...8] RTC daylight saving time setting / RTC DST
Access level: 3 Calculated: - Data type: Unsigned16
Can be changed: U, T Scaling: - Dyn. index: -
Unit group: - Unit selection: - Func. diagram: -
Min Max Factory setting
0 23 [0] 0
[1] 3
[2] 6
[3] 7
[4] 2
[5] 10
[6] 6
[7] 7
[8] 3