Operating Instructions
List of Parameters
Parameters
1-459
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 06/2011
Description: Sets the signal source for the input pulse I of instance PDF 2 of the breaking delay device.
Description: Setting parameter for pulse extension time T in milliseconds of instance PDF 2 of the breaking delay device.
Description: Display parameter for output pulse Q of instance PDF 2 of the breaking delay device.
Description: Setting parameter for the run-time group in which the instance PDF 2 of the breaking delay device is to be called.
Value: 5: Run-time group 5
6: Run-time group 6
9999: Do not calculate
Description: Setting parameter for the run sequence of instance PDE 2 within the run-time group set in p20347.
Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run
sequence value.
p20344 BI: PDF 2 input pulse I / PDF 2 inp_pulse I
Access level: 3 Calculated: - Data type: U32 / Binary
Can be changed: T Scaling: - Data set: -
Units group: - Unit selection: -
Min Max Factory setting
- - 0
p20345 PDF 2 pulse extension time in ms / PDF 2 t_ext ms
Access level: 3 Calculated: - Data type: FloatingPoint32
Can be changed: T Scaling: - Data set: -
Units group: - Unit selection: -
Min Max Factory setting
0.00 60000.00 0.00
r20346 BO: PDF 2 output Q / PDF 2 output Q
Access level: 3 Calculated: - Data type: Unsigned32
Can be changed: - Scaling: - Data set: -
Units group: - Unit selection: -
Min Max Factory setting
- - -
p20347 PDF 2 run-time group / PDF 2 RTG
Access level: 3 Calculated: - Data type: Integer16
Can be changed: T Scaling: - Data set: -
Units group: - Unit selection: -
Min Max Factory setting
5 9999 9999
p20348 PDF 2 run sequence / PDF 2 RunSeq
Access level: 3 Calculated: - Data type: Unsigned16
Can be changed: T Scaling: - Data set: -
Units group: - Unit selection: -
Min Max Factory setting
0 32000 920