Operating Instructions

Parameters

Overview of parameters

1-10

SINAMICS G120 CU230P-2 Control Units List Manual (LH9), 01/2013

The following applies to display parameters:

The fields "Min", "Max" and "Factory setting" are specified with a dash "-" and the

relevant unit in square brackets.

BICO technology: Long parameter name / short parameter name

The following abbreviations can appear in front of the BICO parameter name:

CU/PM variants

Indicates for which Control Units (CU) and/or Power Modules (PM) the parameter

is valid. If no CU or PM is listed, then the parameter is valid for all variants.

The following information relating to "CU" and "PM" can be displayed under the

parameter number:

Note:

The parameter list can contain parameters that are not visible in the expert lists

of the respective commissioning software (e.g. parameters for trace functions).

• BI: Binector input

This parameter is used for selecting the source of a digital signal.

• BO: Binector output

This parameter is available as a digital signal for interconnection

with other parameters.

• CI: Connector input

This parameter is used for selecting the source of an "analog"

signal.

• CO: Connector output

This parameter is available as an "analog" signal for interconnec-

tion with other parameters.

• CO/BO: Connector/binector output

This parameter is available as an "analog" and digital signal for

interconnection with other parameters.

Note:

A BICO input (BI/CI) cannot be interconnected with just any BICO output (BO/CO,

signal source).

When interconnecting a BICO input using the commissioning software, only the

corresponding possible signal sources are listed.

Function diagrams 1020 ... 1030 explain the symbols for BICO parameters and

how to deal with BICO technology.