Operating Instructions

Index
C-725
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 06/2011
7210
AND (AND function block with 4 inputs),
2-603
7212
OR (OR function block with 4 inputs),
2-604
7214
XOR (XOR function block with 4 inputs),
2-605
7216
NOT (inverter), 2-606
7220
ADD (adder with 4 inputs),
SUB (subtracter), 2-607
7222
MUL (multiplier), DIV (divider), 2-608
7224
AVA (absolute value generators), 2-609
7225
NCM (numerical comparator), 2-610
7226
PLI (scaling polyline), 2-611
7230
MFP (pulse generator), PCL (pulse short-
ener), 2-612
7232
PDE (switch-in delay), 2-613
7233
PDF (switch-out delay), 2-614
7234
PST (pulse extender), 2-615
7240
RSR (RS flipflop),
DFR (D flipflop), 2-616
7250
BSW (binary changeover switch),
NSW (numerical changeover switch),
2-617
7260
LIM (limiter), 2-618
7262
PT1 (smoothing element), 2-619
7264
INT (integrator),
DIF (differentiating element), 2-620
7270
LVM (limit value monitor, double-sided
with hysteresis), 2-621
7950
Fixed values, binary selection
(p2216 = 2), 2-631
7951
Fixed values, direct selection (p2216 = 1),
2-632
7954
Motorized potentiometer, 2-633
7958
Closed-loop control, 2-634
7970
Free Technology controller 1, 2, 3, 2-624
7972
Multi Zone Control, 2-625
7973
Essential Service Mode, 2-626
7975
Bypass, 2-627
7976
Staging, 2-628
7978
Hibernation, 2-629
8010
Speed signals 1, 2-636
8011
Speed signals 2, 2-637
8012
Torque signals, motor locked/stalled,
2-638
8013
Load monitoring, 2-639
8014
Thermal monitoring, power module, 2-640
8016
Thermal monitoring, motor, 2-641
8017
Thermal I2t motor model
(PEM, p0300 = 2xx), 2-642
8020
Monitoring functions 1, 2-643
8021
Monitoring functions 2, 2-644
8060
Fault buffer, 2-646
8065
Warning buffer, 2-647
8070
Fault/warning trigger word (r2129), 2-648
8075
Fault/warning configuration, 2-649
8560
Command Data Sets (CDS), 2-651
8565
Drive Data Sets
(DDS), 2-652