Specifications

46
QUICK TEST
If the control unit has remote connections to the Fire Department or other monitor, be sure to
disable the remote signals and notify the remote monitoring station before performing test
operations, since an off-normal condition will be indicated.
The Quick Test mode makes it fast and easy to test a system by eliminating the need to reset
the panel after each device is activated. Quick test is done on a loop basis so that the
remainder of the system will continue to operate normally. Once the loop is placed into quick
test, the NACs will sound for a short configurable period as each device on the loop is
activated. In this way a single person is able to quickly check that each device is working and
activating the system.
The printer may also be enabled or disabled during “Quick Test” as desired.
Refer to the programming manual for the details of accessing the Quick test functions.
For any required service, contact a factory-authorized representative.