Specifications

FS-250 Installation and Operation Manual

Supervisory Conditions

Supervisory troubles are indicated similar to regular system troubles except that when a

supervisory trouble is cleared, the cleared condition continues to be indicated until it is

acknowledged.

Maintenance

In order to insure continued safe and reliable operation of the fire alarm system, periodic

inspection and testing should be performed in accordance with applicable NFPA 72

standards.

If the system has remote connections to the Fire Department or other monitor, be sure to

disable the remote signals and/or notify the remote monitoring station before performing

test operations.

For any required service, refer to the system manual or contact a factory authorized

representative.

ADDITIONAL OPERATING PROCEDURES

In addition to the basic fire alarm instructions above, several features are included to

facilitate maintenance and increase the versatility of the system. Following are procedures

to call up these functions.

Lamp Test

To operate the lamp test, press the MENU button. The LCD display will change to a MENU

screen. Press the button next to the “More” indication twice. Then press the button by the

“Lamp Test” indication. All lamps on the unit being operated will then light. Operating the

button next to “Esc” will then return the control panel to normal display. Note that the lamp

test operates the indicators only on the unit being operated, and no record is reported to

system history.

Drill

To activate a fire alarm drill, proceed as follows:

• Press "MENU".

• On the MENU display, select "More".

• At the next screen, select "DRILL".

• At the next screen, select "Yes".

• Operate ALARM SILENCE to terminate drill signal.

Technical Manuals Online! - http://www.tech-man.com