Environmental Declaration

EPD - Type II
Based on ISO 14021
Building Parts
FDBH291 Detector heating
Siemens Switzerland Ltd
Smart Infrastructure
Theilerstrasse 1a
CH-6300 Zug
Management System since by
ISO 9001 (Quality) 22.07.1989 SQS
ISO 14001 (Environment) 20.10.1998 SQS
OHSAS 18001 (OH&S) 01.01.2011 SQS
Typical energy consumption 9kWh/a
Fire load 1MJ
21-PAP Non-corrugated fibreboard Folding box board 13g
22-PAP Paper Packaging label to FDBH291 1g
22-PAP Paper Enclosing note FDBH291 5g
PE Polyethylen Polyethylen-bag 120/250 2g
Notes on disposal
Total weight of device 16g
The total weight of a device may deviate from the total of the weights of all individual components due to rounding.
PA6; low-halogen Support to FDBH291 4g
PA; low-halogen Cable tie Polyamid 1g
Al alloy Reflector with Foil 8g
Kapton foil and Polyimide film Thermofoil heater 3g
Copper tinned and TFE insulated Cable to hermofoil heater 1g
Polyamid and Cu alloy tinned Microterminal (2 pcs) 2g
PES-Polyester silver matt Label 25 x 8 1g
Comments
EU-directive 2011/65/EU (RoHS)
To the best of our knowledge and according to the information of our suppliers the above mentioned device and its packaging contain no substances of the
candidate list according to Article 59 (1, 10) of the regulation (EC) No. 1907/2006 concerning the Registration, Evaluation, Authorisation and Restriction of
Chemicals (REACH) in concentrations above 0.1 % w/w. Contained REACH candidate substances, which will become known at a later date, are listed on
the delivery note.
(Status according to the creation date of this document.)
Materials
Packaging
Regulation (EC) No. 1907/2006 (REACH)
The device is low-halogen.
Free data entry
Others
The device does not contain substances in concentrations and applications banned under the EU RoHS Directive, including the 4 phthalates added to
Annex II in 2015.
Product
Environmental
Product Declaration
Type of equipment /
Product No.
Process control
Product responsibility of Siemens covers the entire product life cycle. Siemens already assesses, avoids and minimizes
the environmental impact of its products with respect to production, procurement, sales, use, services and disposal during
the product and process planning phases by complying with Siemens EP Standard (former SN 36350) "Specifications on
Environmentally Compatible Product and System Design".
Metals
Product use
Plastics
Environmentally compatible
product design
Restricted Page 1/2