Operating instructions

Maintenance

Siemens Building Technologies 007995_a_en_--.doc

Fire & Security Products 04.2004

6.5 Simulate fault

Overview

By simulating a fault it is possible to check the remote transmission equipment for

faults (e.g. transmission to the fire brigade).

WARNING!

Before simulating a fault, inform accordingly to avoid an unnecessary turning

out.

Procedure

Simulate a fault as follows:

1. Inform accordingly on the pending simulation.

2. Press the numerical key '2' and keep it pressed.

3. Press the zone key '1'.

 A fault is simulated.

 The yellow zone LED is flashing rapidly.

 The fault sequence has been activated.

4. Check whether the fault sequence is correct.

5. To finish the simulation, press the key 'Reset'.