User Manual

Commissioning
30
Building Technologies A6V10265083_b_en_NL
Fire Safety & Security Products 04.2010
7.2 Testing peripheral devices
Procedure
Testing smoke detectors with DZ1193 or RE6
1. Set zone to mode detector test
2. Place testing unit on detector head
3. Wait until LED at detector head is on
4. Remove testing unit
- automatic Reset of test alarm after 10s
5. Set zone to mode normal operation
Testing heat detectors RE6T
1. Set zone to mode detector test
2. Place testing unit on detector head and turn on
heater
3. Wait until LED at detector head is on
4. Remove testing unit
– automatic Reset of test alarm after 10s
5. Set zone to mode normal operation
Testing manual call points
1. Set zone to mode detector test
2. Depending on type of call point, insert test key
or open cover to activate
3. Wait until LED is on
4. Remove test key or close door
- automatic Reset of test alarm after 10s
5. Set zone to mode normal operation
Testing horn control lines
 Initiate horn test with key at the control unit
 Check whether the sound intensity is correct
Testing fire controls
 Make sure that the activation causes no dam-
age to any building equipment
 Activate each fire control by initiating a real
alarm and check whether the fire control functions
are correct