User guide

Note:

The evaluation version of PID 2.0 is provided exclusively for trial use of the development tools and the

SW of the development kit. Further use of the evaluation version is not supported by WindRiver, and it is

not approved for development of products.

2.8.2 Transferring the EB 200 BSP to the Tornado Directory

For PROFINET IO, a special BSP for the evaluation board for VxWorks is included with the

development kit. This BSP must be copied to the Tornado BSP directory.

To do so, proceed as follows:

From the BSP directory of the DK-ERTEC 200 PN IO V3.0 CD, copy the entire ertec200sk subtree to

your Tornado installation directory ( e.g.:D:\Tornado2.2\target\config). The structure of the ertec200sk

subdirectories remains the same.

Copy BSP directory to

LW:

Tornado2.2

tar

confi

Figure 9: Copying the Board Support Package for EB 200 to the Working Directory

2.8.3 Transfering the file bootConfig.c to the Tornado Directory

It was necessary to change the bootloader for the setting of the MAC-Address. The new bootloader

V1.2/2 ist flashed on the EB200 of the DK-ERTEC 200 PN IO V3.0. If you will change the BSP and the

bootloader must be generated new make following step before:

From the BSP directory of the DK-ERTEC 200 PN IO V3.0 CD copy the file bootConfig.c to your

Tornado installation directory ( z.B. :C:\Tornado2.2\target\config\all). Overwrite the existing file

bootConfig.c.

Technical data subject to change Version 3.0.0