Technical data

Copyright © Siemens AG 2013. All rights reserved. 9 EB 200P Manual
Technical data subject to change Version 1.0.1
1.2 Structure of the EB 200P
The EB 200P is implemented in the form of a half-size PCI Express card. The PCI Express interface is used only for
PC mode. In standard configuration the EB 200P is operated as a stand-alone module. The EB 200P is supplied by
means of an external plug-in power supply (part of the development kit).For software debugging a JTAG interface is
available, for more information about JTAG interface is in Chapter 5.
Figure 1: EB 200P with connected debugger
1.3 Features of the EB 200P
In addition to the ERTEC 200P with its integrated function groups, the following elements are available on the
EB 200P:
 PC front panel element with
o 2 RJ45 PROFINET sockets with integrated magnetics, with POF assembly option
o 2 RJ45 TAP sockets for debugging purposes during development for MDI port
o 2 LEDs Link and Activity per RJ45 socket
o 4 LEDs for additional status indicators
o BNC connector for PLL Sync signal
 Flash memory 32 Mbytes, Burst Mode, 2 chips 1Mx16bit in parallel
 SDRAM 128 Mbytes, 2chips 32Mx16bit in parallel
 I2C EEPROM
 SPI temperature sensor
 Debug and trace interface for ARM926EJ-S Microcontroller
 USB Virtual serial interface for monitoring
 Configuration and boot modes can be set via jumpers
 Various operating modes of the EB 200P can be set via jumpers
 Various connectors for external wiring