Manualshelf

Technical data

ManualsBrandsSiemens ManualsComputer equipmentERTEC EB 200
37383940414243444546
Copyright © Siemens AG 2013. All rights reserved. 42 EB 200P Manual
Technical data subject to change Version 1.0.1
7 Settings on the EB 200P
Two connectors for various settings are integrated in the EB 200P. These are used to specify various modes and
selections of function groups on the EB 200P:
o Selection of boot medium and boot software
o Selection of the ERTEC 200P configuration
o Activation/deactivation of different board functions
The exact position of the two connectors is shown schematically in Section 6.
Following picture shows the default configuration of the ERTEC 200P. More information about each jumper
functionality is in chapter 6.12.
Figure 6 EB 200P default configuration of ERTEC 200P