Technical data

Copyright © Siemens AG 2013. All rights reserved. 39 EB 200P Manual
Technical data subject to change Version 1.0.1
Jumper configuration for selecting ERTEC configuration is described in the following table.
Boot configuration
Cfg(6)
Cfg(5) Cfg(4) Cfg(3) Cfg(2) Cfg(1) Cfg(0)
REF_CLK Tristate
x x x x x x Open
REF_CLK Output (25MHz)
x x x x x x Close
ARM Clock 125MHz
x x x x x Close x
ARM Clock 250MHz
x x x x x Open x
PLL Bypa
ss on (Config(1) = Close)
x x x x Close x x
PLL Bypass off
x x x x Open x x
XHIF=16bit, XHIF_XWR = R/W
Close Open x Close x x x
XHIF=16bit, XHIF_XWR, XHIF_XWR separated
Close Open x Open x x x
XHIF=16bit, XHIF_XRDY active high
Close Open Open x x x x
XHIF=16bit, XHIF_XRDY active low
Close Open Close x x x x
XHIF=32bit, XHIF_XWR = R/W
Close Close x Close x x x
XHIF=32bit, XHIF_XWR, XHIF_XWR separated
Close Close x Open x x x
XHIF=32bit, XHIF_XRDY active high
Close Close Open x x x x
XHIF=32bit, XHIF_XRDY active low
Close Close Close x x x x
XHIF=off
Remaining combinations x x x
Table 33 Configuration settings of ERTEC 200P
In the following table is described ERTEC configuration pin header pin out.
Function Signal Pin
Pin Signal
Boot(0) ERTEC EMC DTXR 1 2 4,7k to 1.8V
Boot(1) ERTEC EMC XOE_DRIVER 3 4 4,7k to GND
Boot(2) ERTEC EMC A15 5 6 4,7k to 1.8V
Boot(3) ERTEC EMC A16 7 8 4,7k to GND
Config(0) ERTEC EMC A17 9 10 4,7k to GND
Config(1)
ERTEC EMC A18
11
12
4,7k

to GND
Config(2) ERTEC EMC A19 13 14 4,7k to 1.8V
Config(3) ERTEC EMC A20 15 16 4,7k to GND
Config(4)
ERTEC EMC A21
17
18
4,7k

to 1.8V
Config(5) ERTEC EMC A22 19 20 4,7k to 1.8V
Config(6) ERTEC EMC A23 21 22 4,7k to GND
None NC 23 24 NC
None NC 25 26 NC
None
NC
27
28
NC
None NC 29 30 NC
Table 34 ERTEC 200P configuration header pinout
6.13 Configuration pins for onboard circuits
For this purpose a double row 2x15 SMD pin header with RM 2.54mm (mechanically this pin header is composed
from 2x10 and 2x5 pin header) is assembled. Jumper configuration for selecting FPGA configuration is described in
the following table.
Connector name: X42/X43
Connector type: 2x15-pin plug connector