Technical data

Copyright © Siemens AG 2013. All rights reserved. 36 EB 200P Manual
Technical data subject to change Version 1.0.1
Table 29 Pin assignment of GPIO connector X21
Signal Pin Pin Signal
GPIO80 37 38 GPIO64
GPIO81 35 36 GPIO65
GPIO82 33 34 GPIO66
GPIO83
31
32
GPIO67
GPIO84 29 30 GPIO68
GPIO85 27 28 GPIO69
GPIO86
25
26
GPIO70
GPIO87 23 24 GPIO71
GPIO88 21 22 GPIO72
GPIO89 19 20 GPIO73
GPIO90 17 18 GPIO74
GPIO91 15 16 GPIO75
GPIO92 13 14 GPIO76
GPIO93 11 12 GPIO77
GPIO94 9 10 GPIO78
GPIO95 7 8 GPIO79
NC
5
6
NC
+3.3V 3 4 +5V
+3.3V 1 2 +5V
GND GND 1 GND 2 GND
GND GND 3 GND 4 GND
GND GND 5
Table 30 Pin assignment of GPIO connector X22
6.10 Trace connector for ETM of ARM926EJ-S
For debugging purpose trace port is available over Mictor connector. ERTEC 200P JTAG is accessible via this
connector too. In the following table pin out of trace connector is described.
Connector name: X30
Connector type: 38-pin MICTOR connector