Technical data

Copyright © Siemens AG 2013. All rights reserved. 34 EB 200P Manual
Technical data subject to change Version 1.0.1
Signal Pin
ERTEC
GPIO
GND
1
GND 2
GPIO0 3 GPIO0
GPIO1 4 GPIO1
GPIO2 5 GPIO2
GPIO3 6 GPIO3
GPIO4 7 GPIO4
GPIO5 8 GPIO5
GPIO6
9
GPIO6
GPIO7 10 GPIO7
GPIO8 11 GPIO16
GPIO9 12 GPIO17
GPIO10 13 GPIO18
GPIO11
14
GPIO19
GPIO12 15 GPIO20
GPIO13 16 GPIO21
GPIO14 17 GPIO22
GPIO15 18 GPIO23
+3.3V 19
+3.3V 20
Table 26 Pin assignment of GPIO connector X50
6.8 JTAG connector for FPGA
For programming a 10 pin JTAG connector is assembled. Double row 2x5 SMD pin header with RM 2.54mm is used.
Pin out of this connector is described in the following table.
Connector name: X32
Connector type: 2x5-pin plug connector
Note Pin Signal Signal Pin
4.7k pull down 1 TCK GND 2
3 TMS GND 4
5 TDI Vccj(3.3V) 6
7
TDO
GND
8
9 DONE PROGRAMN 10
Table 27 Pin assignment of FPGA JTAG connector X32
6.9 GPIO [95 to 0] connectors
There are 3 Mictor connectors on EB 200P which are connected to all 96 ERTEC 200P GPIOs. Maximum allowed
consumption from all Mictor connectors is 100mA for 5V and 100mA for 3.3V. In the following tables pin out of use
case connectors are described. GPIOs in the table are ERTEC 200P GPIOs.
Connector name: X20-22
Connector type: 38-pin MICTOR connector type 5767054