Technical data

Technical data subject to change Version 1.0.1

6.4 Sync connector

For synchronization measurement the BNC connector is assembled and alternatively the 3 pin connector as assembly

option. Signals on 3pin connector are RS485 signals. In the following table pin outs of sync connectors are described.

Connector name: X2

Connector type: BNC

Signal Pin Signal

BNC

Tip

Sync In/Out*1

Shield GND

3 pin

connector

Sync RS485 P

2 Sync RS485 N

3 GND via100k

Table 22 Pin assignment of external synchronization connector

Note: *1 Configured by jumper at one time can be connected only input or output

6.5 USB-UART Interface

For UART to USB conversion a convertor from TI is assembled. For USB connection is used mini B connector. In the

following table pin out of USB connector is described.

Connector name: X11

Connector type: USB Mini-B connector

Signal Pin

VBUS

D-

D+ 3

ID (NC}

GND 5

Table 23 Pin assignment of USB Mini-B connector

6.6 EMC interface

To connect additional devices to the EMC bus, Mictor 38 WAY sockets type 5767054 are prepared on EB 200P. In the

following table pin out of EMC connectors is described. This interface is behind level shifters and runs at 3.3V .

Note:

To use external EMC Peripherals it is necessary to assemble EMC data level shifter to EB 200P (D16,

D17) and add control signal logic (R415, R416). This is application depending.

Connector name: X80/X81

Connector type: 38-pin MICTOR connector