Technical data

Copyright © Siemens AG 2013. All rights reserved. 3 EB 200P Manual
Technical data subject to change Version 1.0.1
Preface
Contents of this Manual
 Detailed description of the individual function groups of the EB 200P
 Connector pin assignment and jumper assignment
Target Audience of this Manual
This manual is intended for hardware developers who want to use the ERTEC 200P for new products. Experience
working with processors and designing embedded systems and knowledge of Ethernet are required for this.
The manual serves as a reference for software developers. Sections 7 and 8 describe the jumper settings and
connectors that are required for software tests (e.g. debugging, terminal outputs, etc.).
Structure of this Manual
This manual describes the ERTEC 200P evaluation board. The manual is structured as follows:
o Section 1 Introduction
o Section 2 Hardware Structure of the EB 200P
o Section 3 Memory Distribution of the EB 200P
o Section 4 Operating Modes of the EB 200P
o Section 5 JTAG Interface of the EB 200P
o Section 6 Settings of the EB 200P
o Section 7 Connectors of the EB 200P
o Section 8 Jumpers of the EB 200P
o Section 9 Mechanical Structure of the EB 200P
o Section 10 List of Terms and References
When working with modules, always take precautionary measures against electrostatic charge
(ESD – Electrostatic Sensitive Devices).
For module handling and installation, refer to /1/.
This manual will be updated as required. You can find the current version of the manual on the Internet at
http://www.siemens.com/comdec
.