Technical data

Technical data subject to change Version 1.0.1

2.6 Ethernet Interfaces of the EB 200P

2.6.1 Ethernet ports (X1)

Two 100Mbit/s full duplex ports are available in ERTEC 200P. PHYs are integrated in ERTEC 200P package. Only

external magnetics with RJ45 connector are necessary for PROFINET functionality.

In the following table pin out of both wired Ethernet ports is described.

RJ45 Ethernet port Pin

Port 1 Rx+ 1

Port 1

Port 1 Tx+ 3

Port 1 Tx- 6

Port 2 Rx+ 1

Port 2 Rx- 2

Port 2

T x+

Port 2 Tx- 6

Table 15 Ethernet ports pinout

2.6.2 TAP ports (X1)

The Ethernet port one has integrated TAP functionality on board. Two additional Ethernet ports are necessary for this

functionality. TAP can be used only with wired twist pair connection. In the following table pin out of both TAP ports is

described.

RJ45 TAP port Pin

TAP A Tx+ 1

TAP A Tx- 2

TAP B Tx+ 1

TAP B

Table 16 TAP ports pinout

Remaining pins are not connected. LEDs on TAP connectors are not used.

2.6.3 POF Transceiver ports (X3, X4)

POF Transceiver has no external electrical connection; no media converter is possible. POF Transceivers are

assembly option. TAP functionality is not available with POF Transceivers.