Technical data

ManualsBrandsSiemens ManualsComputer equipmentERTEC EB 200

Technical data subject to change Version 1.0.1

Function Color Position Connection Resistor

Sync Green Bracket GPIO(29) 750

P Green Bracket PSU 750

MT Yellow Bracket GPIO(26) 750

Error Red Bracket GPIO(25) 750

Power Green PCB PSU 750

Error Red PCB GPIO(25) 750

Maintenance Yellow PCB GPIO(26) 750

Diagnostic

Yellow

PCB

GPIO(27)

750



PROFIenergy

Green PCB GPIO(28) 750

Sync Green PCB GPIO(29) 750

FO-1 Yellow PCB GPIO(30) 750

FO-2 Yellow PCB GPIO(31) 750

Table 10 Status LEDs connection

Status LEDs can not be disconnected from GPIOs by any configuration jumper. Configuration is fixed.

2.3.2 Synchronization output and input

For measurement of delays during synchronized state, external connectors are assembled. Two types of connectors

with different electrical functionality can be used.

The first one is BNC connector available on the bracket. This connector is unidirectional and cannot be used for both

ways at one time. Direction will be switched by jumper to achieve zero delay (no switch, no buffer).

The second possibility is a three pin connector like it is used on EB 200. Connector is connected to ERTEC GPIOs via

RS485 interface. Direction is controlled by ERTEC 200P.

Connection is described in the following table. For RS485 input output is described convertor connection. Connector

pin out is described in chapter 2.1.2.

Connector/Convertor

Connection

Note

BNC

In GPIO(9) Configuration via jumper

Out GPIO(0) Configuration via jumper

RS485

R GPIO(9)

D GPIO(0)

DE GPIO(16)

XRE GPIO(17)

Table 11 Synchronization input/output connection

2.3.3 SPI temperature sensor

Simple SPI temperature sensor is connected to ERTEC 200P GPIOs via bidirectional bus switch (SN74CB3Q3384). A

SPI sensor can be connected or disconnected by configuration jumper. The following table describes the connection

between sensor pins and ERTEC’s GPIOs (via bus switch).

Signal Signal function Connection Note

Data out SPI_SSPRXD(1a) GPIO(19) Pull down 1k

SCK Clock SPI_SCLKOUT(1a) GPIO(16) Pull down 1k

XCS

Chip select SPI_SFRMOUT(1a) GPIO(17) Pull up 1k to 3.3V

Table 12 SPI temperature sensor connection