Technical data

ManualsBrandsSiemens ManualsComputer equipmentERTEC EB 200

Technical data subject to change Version 1.0.1

2.1.8 General Purpose Interface (GPIO)

The GPIO interface of the ERTEC 200P consists of 96 I/O that can be configured for different functionality. GPIO(15-

0) pins have interrupt capability.

Pins can be split to several groups regarding configuration jumpers:

GPIO(31-0) : GPIO except when CFG(6:3) = “1100”

GPIO(63-32) :

 XHIF when CFG(6:3) = depending on XHIF Mode see Table 5

 TRACE port when CFG(6:3) = “1110”

 otherwise GPIO

GPIO(95-64) :

 XHIF when CFG(6:3) = depending on XHIF Mode see Table 6

 TRACE port when CFG(6:3) = “1110”

The following tables describe the interconnections between test and debug circuits and ERTEC 200P. Not all

components can be connected or disconnected from ERTEC GPIOs.

Status LED

NAND

FLASH

BNC

Sync

RS485

Sync

I2C

EEPROM

SPI Temp

Configuration

by bus

switch

no yes no no yes yes

Configuration

by jumper

no no yes no no no

GPIO(0) - -

Sync

Out*1

D*2 - -

GPIO(1) - - - - - -

GPIO(2) - - - - - -

GPIO(3) - - - - - -

GPIO(4) - - - - -

GPIO(5)

GPIO(6) - - - - - -

GPIO(7)

GPIO(8) - - - - - -

GPIO(9) - -

Sync

In*1

R*2 - -

GPIO(10) - R/XB - - - -

GPIO(11) - - - - - -

GPIO(12) - - - - - -

GPIO(13) - - - - - -

GPIO(14) - - - - I2C_SCLK -

GPIO(15) - - - - I2C_SDOI -

GPIO(16)

DE*2

SPI_SCLKOUT

GPIO(17) - - - XRE*2 - SPI_SFRMOUT

GPIO(18)

GPIO(19) - - - - - SPI_SSPRXD

GPIO(20)

GPIO(21) - - - - - -

GPIO(22) - - - - - -

GPIO(23) - - - - - -