Technical data

7.11 CPLD Programming Interface

The two PLDs on the EB 200 can be parameterized with a programming adapter. The two PLDs are connected in a

daisy chain pattern.

Connector name: X63

Connector type: 1x8-pin plug connectors

Pin Signal Name Type Meaning

1 P3V V Supply

2 TDO O Serial data out

3 TDI I Serial data in

4 - - -

5 - - -

6 TMS I Test mode select

7 M V Ground

8 TCK I Test clock

Table 26: Pin Assignment for CPLD Programming Interface

8 Settings on the EB 200

Two connectors for various settings are integrated in the EB 200. These are used to specify various modes and

selections of function groups on the EB 200:

o Selection of boot medium and boot software

o Selection of the ERTEC 200 configuration

o Activation/deactivation of different board functions

The exact position of the two connectors is shown schematically in Section 7.

he following convention applies to all connectors:

 0 = Jumper connected

 1 = Jumper not connected

8.1 Boot/Configuration Connector X10

Connector X10 is used to specify the boot modes and, in some cases, the configuration modes on the EB 200.

Connector name: X10

Connector type: 2x8 pin male connector

Pin Signal Name Type Meaning

1 M

2 BOOT[0]

3 M

4 BOOT[1]

5 M

6 BOOT[2]

7 M

8 BOOT[3]

9 M

10 CONFIG[1]

11 M

12 CONFIG[2]

13 M

14 CONFIG[3]

15 M

16 CONFIG[4]

Technical data subject to change Version 1.1.4