Operating instructions

en PowerBoost function
14
Once the time has elapsed
The hotplate switches off. A beep sounds and in the
time program function display
‹‹ appears for
10 seconds. The Ú indicator on the hotplate lights up.
Pressing the 0 symbol turns off the indicators and
stops the beeping.
Notes
■ If a cooking time has been set for several hotplates,
the cooking time that was set last appears in the
timer display.
■ To select the remaining cooking time for a different
hotplate, touch the 0 symbol repeatedly until the
indicator for the desired hotplate lights up.
■ You can set a cooking time of up to 99 minutes.
The kitchen timer
You can use the kitchen timer to set a time of up to 99
minutes.
This functions independently from the hotplates and
from other settings. This function does not automatically
switch off a hotplate.
Setting procedure
1. The kitchen timer can be set in two different ways:
– If a hotplate has been selected, touch the
0 symbol repeatedly until the Ú indicator beside
the V symbol lights up.
– If no hotplate has been selected, touch the
0 symbol. The Ú indicator beside the V symbol
lights up.
‹‹ appears on the timer display.
2. Touch the @ or A symbol. The basic setting is
displayed.
@ symbol: 10 minutes.
A symbol: 05 minutes.
3. Use the @ or A symbol to set the required time.
After a few seconds, the time begins to count down.
Changing or deleting the time
Touch the symbol 0 repeatedly until the Ú indicator
lights up beside the V symbol. Change or set the time
to ‹‹ using the @ or A symbol.
Once the time has elapsed
A warning signal sounds. ‹‹ is displayed on the time
program function display. After 10 seconds the
indicators turn off.
Pressing the 0 symbol turns off the indicators and
stops the beeping.
vPowerBoost function
Po we r Bo o s t function The PowerBoost function enables you to heat up large
quantities of water faster than when using heat setting
Š.
This function can always be activated for a hotplate,
provided the other hotplate in the same group is not in
use (see illustration). Otherwise, the
› symbol and the
heat setting will flash in the hotplate display; the
previously selected heat setting will then be set
automatically without activating the function.
Note: In the combi zone, the PowerBoost function can
only be activated if the two hotplates are used
independently of each other.
Activation
1. Selecting the required heat setting.
2. Touch the & symbol for the selected hotplate.
› lights up on the display.
The function is activated.
Deactivation
Touch the & symbol.
› goes out on the display and the hotplate switches
back to the previously selected heat setting.
The function is deactivated.
Note: In certain circumstances, the PowerBoost
function can switch itself off automatically in order to
protect the electronic elements inside the hob.

