Specifications

Installation Instructions
8
7. Lower trip unit onto support plate.
After the connector has been mated, lower (push) the trip unit
onto the support plate.The pins on the support plate will fit
into the holes in the bottom of the trip unit.
8. Secure trip unit.
Secure the trip unit in place with the retaining screw located
at the top of the trip unit.Torque 6 and 8 in-lbs. If trip unit top
is not secured correctly, the interlock will prohibit closing of
the breaker.
9. Replace the front cover.
Replace the front cover.Then, replace the eight (8) front cover
screws. If trip unit top is not secured correctly, the interlock
will prohibit closing of the breaker.
NOTE: Before energizing breaker be sure to install a cor-
rect rating plug. See pages 10 and 11.