Operation Manual

12
The timer
The timer can be set for periods of up to 99 minutes. It is
independent of the other settings. This function does not
automatically switch off a hotplate.
How to program
1. Press the 0 symbol several times until the W indicator lights
up.
‹‹ is displayed in the time program function display.
2. Select the required time using one of the control discs.
The timer starts to count down after a few seconds.
Once the time has elapsed
A warning beep sounds. In the time program function display
‹‹ is shown, and the W indicator comes on. After 10 seconds
the indicators turn off.
Pressing the
0 symbol turns off the indicators and stops the
beep.
Changing or cancelling the time
Press the
0 symbol several times until the W indicator lights
up. Change the time using one of the control discs or set
to
‹‹.
Automatic time limitation
If the hotplate remains in use for a long time and no changes
are made in the settings, the automatic time limitation function
is triggered.
The hotplate stops heating. On the hotplate display,
”and ‰
flash alternately.
The indicator goes out when any symbol is pressed. The
hotplate can now be reset.
When the automatic time function is used, it is governed by the
selected power level (from 1 to 10 hours).
Cleaning protection
Cleaning the control panel while the range is on may change
the settings.
In order to avoid this, the range has a cleaning protection
function. Press the
#symbol. An audible signal sounds. The
control panel is locked for 35 seconds. The surface of the
control panel can now be cleaned without risk of changing the
settings.
Note: The lock does not affect the main switch. The range may
be switched off when desired.