Technical data

Basic information about the drive system
10.8 Licensing
Function Manual
Function Manual, 06/2012, 6SL3097-4AB10-0BP4
721
System response where license is insufficient for a function module
An insufficient function module license is indicated via the following fault and LED on the
Control Unit:
● F13010 Function module license, not licensed
● The OFF1 response brings the drive to a standstill.
● RDY LED permanently lit
NOTICE
The drive system cannot be operated if the license for a function module is insufficient.
The drive requires a sufficient license in order for it to operate normally.
Properties of the license key
● Is assigned to a specific memory card.
● Saved in non-volatile memory.
● Is not transferrable.
● Can be acquired using the "WEB License Manager" from a license database.
Generating a license key via the "WEB License Manager"
The following information is required:
● Serial number for the memory card
● License number and delivery note number of the license (on the Certificate of License)
1. Call up the "WEB License Manager".
http://www.siemens.com/automation/license
2. Choose "Direct access".
3. Enter the license number and delivery note number of the license.
→ Click "Next".
4. Enter serial number.
5. Select a product, e. g. "SINAMICS S CU3xx".
→ Click "Next".
6. Choose "Available license numbers".
→ Click "Next".
7. Check the assignment.
→ Click "Assign".
8. When you are sure that the license has been correctly assigned, click "OK".
9. The license key is displayed and can be entered.