Technical data

Communication
9.2 Communication according to PROFIdrive
Function Manual
Function Manual, 06/2012, 6SL3097-4AB10-0BP4
615
Error values in DPV1 parameter responses
Table 9- 33 Error values in DPV1 parameter responses
Error
value
Meaning Remark Additional
info
0x00 Illegal parameter number Access to a parameter which does not exist. –
0x01 Parameter value cannot be changed Modification access to a parameter value which cannot be
changed.
Subindex
0x02 Lower or upper value limit exceeded Modification access with value outside value limits. Subindex
0x03 Invalid subindex Access to a subindex which does not exist. Subindex
0x04 No array Access with subindex to an unindexed parameter. –
0x05 Wrong data type Modification access with a value which does not match the
data type of the parameter.
–
0x06 Illegal set operation (only reset
allowed)
Modification access with a value not equal to 0 in a case
where this is not allowed.
Subindex
0x07 Description element cannot be
changed
Modification access to a description element which cannot
be changed.
Subindex
0x09 No description data Access to a description which does not exist (the
parameter value exists).
–
0x0B No operating priority Modification access with no operating priority. –
0x0F No text array exists Access to a text array which does not exist (the parameter
value exists).
–
0x11 Request cannot be executed due to
operating status
Access is not possible temporarily for unspecified reasons. –
0x14 Illegal value Modification access with a value which is within the limits
but which is illegal for other permanent reasons
(parameter with defined individual values).
Subindex
0x15 Response too long The length of the present response exceeds the maximum
transfer length.
–
0x16 Illegal parameter address Impermissible or unsupported value for attribute, number
of elements, parameter number, subindex or a
combination of these.
–
0x17 Illegal format Write request: illegal or unsupported parameter data
format
–
0x18 No. of values inconsistent Write request: a mismatch exists between the number of
values in the parameter data and the number of elements
in the parameter address.
–
0x19 Drive object does not exist You have attempted to access a drive object that does not
exist.
–
0x65 Presently deactivated. You have tried to access a parameter that, although
available, does not currently perform a function
(e.g. n control set and access to a V/f control parameter).
–
0x6B Parameter %s [%s]: no write access
for the enabled controller
– –
0x6C Parameter %s [%s]: unit unknown – –