Technical data

Function Manual

Function Manual, 06/2012, 6SL3097-4AB10-0BP4

Commissioning with PROFIBUS

3.1 Sequence of operations during commissioning

Once the basic requirements have been met, you may proceed as follows to commission the

drive:

Table 3- 1 Commissioning

Step Activity

1 Create project with STARTER.

2 Configure the drive unit in STARTER.

3 Save the project in STARTER.

4 Go online with the target device in STARTER.

5 Load the project to the target device.

6 The motor starts to run.

Note

If motors with a DRIVE-CLiQ interface are used, all motor and encoder data should be saved

in a non-volatile manner for spare part usage of the Sensor Module on the motor via p4692 =