Technical data

Drive functions
7.2 Basic functions
Function Manual
Function Manual, 06/2012, 6SL3097-4AB10-0BP4
185
Groups of units
Every parameter that can be changed over is assigned to a units group, that, depending on
the group, can be changed over within certain limits.
This assignment and the unit groups for each parameter are listed in the parameter list in the
SINAMICS S110 List Manual.
The units groups can be individually switched via the following parameters: p0100, p0505
and p0595
Function in STARTER
To call up the function for converting units in STARTER, choose Drive object → Configuration
→ Units. The reference parameters can be found under Drive object → Configuration →
Reference parameters.
Overview of important parameters (see SINAMICS S110 List Manual)
● p0010 Commissioning parameter filter
● p0100 Motor Standard IEC/NEMA
● p0505 Selecting the system of units
● p0595 Selecting technological units
● p0596 Reference quantity, technological units
● p2000 CO: Reference frequency/speed
● p2001 CO: Reference voltage
● p2002 CO: Reference current
● p2003 CO: Reference torque
● r2004 CO: Reference power
● p2005 CO: Reference angle
● p2007 CO: Reference acceleration